Presets
LOGIQ V2/LOGIQ V1 – User Guide 3-19
Direction 5610736-100 Rev. 9
EZBackup and EZMove (continued)
Basically, when you perform the EZBackup or EZMove
procedure, you insert the media (or connect USB HDD if
applicable), the system backs up/moves the images (or reports),
and creates a reference between the patient database and the
media’s volume.
NOTE: EZBackup/EZMove can take up to 20 minutes (or longer,
depending on the size of the backup). Make sure to schedule
this at the same time daily, when no patients are scheduled.
1. Prepare unformatted media or the USB HDD before starting
EZBackup/EZMove.
2. Specify the EZBackup/EZMove setup on the Utility -->
System --> Backup/Restore page.
3. To start the EZBackup/EZMove procedure, go to the
Archive Screen and select EZBackup/EZMove. The
EZBackup/EZMove Wizard starts.
NOTE: If you use the USB HDD, some wizards and the pop-up
messages DO NOT appear.
To Next Page
Loading...
