GE LOGIQ V2

Getting Started
1-68 LOGIQ V2/LOGIQ V1 – User Guide
Direction 5610736-100
Rev. 9
Entering a Patient List (For R1.1.x)
All patient information can be entered before starting an exam.
1. Press Patient to display the Patient Screen.
2. Press New Patient to erase the current patient data.
3. Select Store All if data from previous patient was not saved.
4. Enter the Patient ID.
5. Enter the patient and exam information.
6. Press Register.
7. Repeat above steps as required.
Select the patient from the Patient List. Select Resume Exam to
continue the last exam that was performed on the selected
patient.
Select New Exam to start a new exam on the selected patient.