– 33 –
Grill Burner Igniter
Note: The following describes the procedure to
remove the grill burner igniter. The grill igniter
has a resistance value of 45 to 400 Ω at room
temperature.
To remove the grill burner igniter:
Remove the grill burner. (See 1. Grill Assembly.)
Note: In the following step, ensure that the spring
clip is captured and retained inside the grill burner
box.
Squeeze the ends of the spring clip and retract 2.
the clip from the harness access cutout on the
left side of the grill burner box.
3. Pull the harness connector thru the cutout and
disconnect the igniter wire harness.
Spring Clip
Grill Safety Valve
Note: The following describes the procedure to
remove the grill safety valve. The grill safety valve
has a resistance value of 1 Ω or less.
To remove the grill safety valve:
Remove the grill assembly. (See 1. Grill Assembly.)
Remove the two 1/4-in. hex-head screws that 2.
attach the heat shield.
3. Disconnect the wires from the valve.
4. Remove the heat barrier.
5. Remove the 9/16-in. nut from the valve.
6. Remove the 1/4-in. hex-head screw that
attaches the valve to the valve bracket and
separate the valve from the gas tube and valve
bracket.
Heat Shield
Heat Barrier
Disconnect
Disconnect
To Next Page
Loading...
