ā 55 ā
If there is debris in the slide tracks, wipe it 3.
away, using a paper towel.
Note: Any graphite lubricant wiped away must be
replaced.
Shake the graphite lubricant before opening it. 4.
Starting with left slide mechanism of the rack,
place 4 small drops of lubricant on the 2 bottom
tracks of the slide close to the bearing carriers.
Repeat for the right slide mechanism of the rack.5. 2. Fully extend the rack on a table or countertop.
Newspaper may be placed underneath the
rack for easy clean up.
Open and close the rack several times to 6.
distribute the lubricant.
Replace the cap on the lubricant and shake it 7.
again. Turn the rack over and repeat steps 3, 4,
5 and 6.
Close the rack. Turn rack right-side-up and 8.
install in the oven.
Repeat above steps for each rack.9.
Note: Do
not use a cooking spray or other lubricant
spray on the slides.
Left side
Rack right-side-up
Right side
Rack right-side-up
To Next Page
Loading...
