ā 64 ā
7. Untape the retrieval wire from the probe wire
harness connector.
Note: Upon reassembly, ensure displaced insulation
is returned to it's original position.
To remove the meat probe receptacle harness:
Remove the range from the installation.1.
Remove the back panel. (See 2.
Back Panel.)
Disconnect the meat probe outlet wire harness.3.
Disconnect
Side Access Panel
Retrieval Wire
5. Remove the meat probe receptacle. (See
To remove the meat probe receptacle, this
section.)
4. Tape a length of wire to the probe wire harness
connector to act as a retrieval wire.
6. Carefully pull the probe wire harness, and part
of the retrieval wire through the light housing
opening.
To Next Page
Loading...
