GE P444 - Page 610

P44x/EN VH/H
b6 Hardware / Software-
Version
(VC) 16
-6
MiCOM P40 Agile P442, P444
Relay type: P441, P442, P444
Software
version
Hardware
version
Model
number
Date of
issue
Full Description of changes S1 Compatibility
Branch B1.x :
New Hardware Platform (150 MHz coprocessor Board -2nd rear port-Triptime= 1,1 Cycle - 48 samples/T) & New functions (32N & 59N)
B1.0
C
08
12/2002
New platform/model 080C/coprocessor board at 150 MHz/PW (32N)/CVTS
(59N) new functions/ Px4X with Px3x in IEC103 / Retrip CB/Ffu/31st December
for Drec/I Brok.cond./DEF polar.
V2.09
B1.1 09
07/2003
Synchrocheck ext correction & PPhase ref & L-Live / 32N correction / Line
angle<55° / Voltage memory / Power swing & Z glitch
V2.09 + patch*
B1.2 09
09/2003
Disturbance compressed & not compressed function and communication
correction/2UN Vref Sync/Zn-Zn+1 with +30msec
V2.09 + patch*
B1.3 09
07/2004
Synchro TP bus/Optos taging in event/ZSP angle/Dynamic management Bus-
Line for checksync
V2.09 + patch*
B1.4
09
09/2004 New plateform /Timesync cell in ModBus /DNP3 V2.09 + patch*
B1.5
09
11/2004
CB close command is applied 2 time from DNP3
Fault location-Settings group by opto-DNP3 & model N°
V2.09 + patch*
B1.6
09
04/2005
32N corrected (5Amp) -
Primary measurement & Im
V2.09 + patch*
B1.7
09 06/2005
ModBus/ VTS alarm using V2
V2.09 + patch*
Note: The software version / hardware version / model number can be found through the setting in “system data” via MiCOM S1 or LCD front panel.
Patch 09 is included with MiCOM S1 version V2.11
Note 2: Version B1.0, to B1.3 not distributed (mandatory upgrade). Version B1.4 to B1.7: Recommanded upgrade.