GE P444 - Page 612

P44x/EN VH/H
b6 Hardware / Software-
Version
(VC) 16
-8
MiCOM P40 Agile P442, P444
Relay type: P441, P442, P444
Software
version
Hardware
version
Model
number
Date of
issue
Full Description of changes S1 Compatibility
Branch C2.x :
Idem C1.x with UCA2 (Ethernet optical support) & new function (49+NCIT)
C2.0
G - J
for P441/442
G - J - H
for P444
30
08/2004
New platform- NCIT/ Thermal Overload as P540/ Synchro TP bus/ Optos
tagging in event/ ZSP angle/ Dynamic management Bus-Line for checksync/
DEF Reverse sensitivity/ Time sync input/ ZSP start/ Ethernet module NCIT
61850-9-2
V2.10 + patch*
or
V2.11
C2.1
30
09/2004
Timer 0/DNP3 correction
C2.2
30
10/2004
InterMicom/ DEF primary scale/ AREVA name in UCA2
C2.5 30
11/2004
Phase select. PPground/ Reset IN dead/ DNP3 & CB Close/ Floc/ Opto& setting
group selection/ DNP3
C2.6 30
05/2005
Primary measurement & Im - Error during flash with optical fiber/ Floc&Broken
currents new cells in DNP3-E2.0 official platform with NCIT
C2.7 30
07/2005
UCA2 no longer supported (from that version onwards)/ Add phase voltage
inversion detection in Voltage Transformer Supervision (V2 presence without I0
and I2)./
Add IEC61870-5-103 Generic Services
C2.8 30
02/2006
P0 time delay/ NCIT sampling/Extended mode with DRec/ OpticFiber with KBus
model/ Tilt angle & K0/ Reset latch DDB& LEDs
V2.12 + patch
C2.9 30
03/2006
DNP3/ PreTrigger in DRec/ Tilt angle & K0/ C264 compatibility in DNP3/ Reset
VTS 3phases
C2.10c
30
05/2006
Add Chinese HMI (First implementation, will become standard in next version)
C2.11
to
C2.16
30
052007
Zone reset&overlap/ WeakInfeed Echo+DEF/ Control Inp/ Z1ext+Tilt/ Selfcheck
Output board/ DRec & 5Amp/ Start D & Phase Selection/ Timer&Thermal Protec
5Amp
V2.14
C2.17-S
30
2011
New Alstom Grid
Note 1: Software version / hardware version / model number can be found by setting in “system data” with MiCOM S1 or LCD front panel.
Note 2: Version C2.0 and C2.1, 2.10c – C2.11 not distributed (mandatory upgrade). Versions C2.2 to C2.8 and C2.12 to C2.15: Recommended upgrade.
Note 3: Patch 20 & 30 are included with MiCOM S1 version V2.11