-
2. CONFIGURING THE ETHERNET INTERFACE
The way in which you configure the Ethernet interface depends on the particular type of
interface you have. If you have a DNP3.0 interface, use the DNP setting file to configure the
Ethernet interface. Otherwise you should use the IED configurator tool in MiCOM S1 Agile.
Note: Further information is available in the Communications chapter
2.1 Configuring the Ethernet Interface for IEC 61850
1. Open MiCOM S1 Agile:
2. Select Tools > IEC61850 IED Configurator
3. Select Device > Manage IED
4. Select Px40
5. Enter the address of the IED you want to manage (this will always be '1' if you are
connected via the front port)
6. Click Next. The following screen appears
7. Select Extract Configuration, Active Bank
To Next Page
Loading...
