Getting started
88 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
5. Position the probe cable so that it is not resting on the floor.
Figure 2-13: RS Probe Connection Locking Lever
To connect a probe (Large connector - type
OR)
1. Hold the probe connector vertically with the cable pointing
upward.
2. Turn the connector locking handle to the horizontal
position.
3. Align the connector with the probe port and carefully push
into place.
4. Rotate the locking handle to the full vertical position to lock
in place.
Cable Handling
Take the following precaution with probe cables:
• Do not bend the cable acutely.
CAUTION
Take the following precautions with the probe cables:
• Keep free from the wheels.
• Do not bend the cables
• Do not cross cables between probes
CAUTION
Fault conditions can result in electric shock hazard. Do not touch
the surface of probe connectors which are exposed when the
probe is removed. Do not touch the patient when connecting or
disconnection a probe.
To Next Page
Loading...
