Getting started
Vivid S5/Vivid S6 User Manual 61
R2424458-100 Rev. 2
Switching On/Off
To switch on the unit:
1. Switch on the circuit breaker on the rear of the unit (see
Figure 2-6).
2. Press (on/off button) on the top left of the control panel
(see Figure 2-11).
After initialization the default scanning screen (2D mode) is
displayed, the active probe being the one connected to the
left most connector socket.
When turning ON
a system while sys-
tem is in standby, it
takes a few seconds
before it responds.
Do not push the
on/off button again
during this period
(A second push will
initiate a full shut-
down).
LEDs
There are two LEDs above the On/Off switch that indicate the
status of the system.
Password Protection
Log In
By factory Login
default, the Opera-
tor ID is USR and
there is no need to
enter a password
During the turn-on process the system may require the user to
enter a password in order to operate it. Personal IDs and
associated passwords can be configured in the
Vivid S5/Vivid S6. See "Presets and System setup" on
page 583 for more information.
If IDs and passwords have been entered and "Use Auto Logon"
is Off (see "Users" on page 637 for details), the Operator Login
window appears, requesting for an ID and password when
Power up sequence is completed, or when it is required.
Indicates power status.
After pressing the On/Standby switch, the system
power is ON and this LED is lit.
Color: Green
Indicates battery status.
When the battery is charged, the LED is green.
When the battery power is low, the LED is orange.
Color: Green and Orange
To Next Page
Loading...
