GE Vivid S5 - The Assign and Measure Modality; Starting the Assign and Measure Modality

Measurement and Analysis
248 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
The Assign and Measure modality
In this measurement modality, the user selects a study
consisting in a set of related pre-labelled measurements.
Starting the Assign and Measure
modality
1. Press MEASURE on the control panel.
The Measurement Menu is displayed in the Parameters
window (see example Figure 7-2).
The trackball cursor is in the parameter window, ready for
measurement selection.
Figure 7-1: Example of a measurement study
1. Active application
2. Study
3. Selected study
4. Opened study
5. Measurements related to the
area study for the cardiac
application