Quantitative Analysis
Vivid S5/Vivid S6 User Manual 397
R2424458-100 Rev. 2
Switching modes or traces
The user can toggle between TVI, Tissue Tracking, Strain rate
or Strain modes to access to the mode specific controls (soft
menu and assignable) or display alternative traces from within
a selected mode.
To switch mode
1. Press MORE.
2. Select the desired mode (TVI, Tissue Tracking, Strain rate
or Strain.
The Soft menu and assignables are updated accordingly.
To switch trace
1. If necessary, press TRACKBALL until the QA trackball
assignment is selected.
2. Trackball to the Analysis window.
3. Press
UPDATE MENU in the trackball area on the control
panel.
The System menu is displayed.
4. Trackball to Analysis signal.
5. Press
SET.
The Analysis signal menu is displayed.
Figure 8-7: The Analysis signal menu
6. Trackball to the desired trace.
7. Press
SET.
The Analysis window is updated with the selected trace.
To Next Page
Loading...
