Basic scanning operations
104 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
Using the Assignable Keys Soft Menu
The bottom of the display screen contains a graphics area of
soft-menu with assignable keys and rotaries. This area of the
screen is designed to match a parallel set of physical buttons
(the assignable keys and rotaries [refer to Figure 3-1]), located
on the upper portion of the control panel. An example of a
soft-menu is shown in below.
Figure 3-2: The Assignable Keys and Soft Menu
The soft-menu provides access and user control of different
system parameters.
The contents of the soft-menu is different for every system
mode. This provides access to the relevant settings in each of
the different modes.
There are several different control key elements in the
soft-menu area, as follows:
Variable Single parameter rotary knob
In this example, the “Baseline” parameter can be increased by
rotating the corresponding rotary knob clockwise. The same
parameter can be decreased by rotating the same rotary knob
counterclockwise. Upon rotating the knob the arch on the
graphics changes its length to reflect the change in the value of
the controlled parameter.
To Next Page
Loading...
