Stress Echo
Vivid S5/Vivid S6 User Manual 231
R2424458-100 Rev. 2
When Continuous capture is selected, preview of cineloop
and reference display (see below) during acquisition are
not possible.
Preview of store
• Check Preview of store if review and adjustment of
cineloops before storage is desired.
Show reference
• Check Show reference if the display of the corresponding
reference loop is desired during acquisition (dual screen
mode).
Adding a group
1. In the Protocol template preview field select the cells to be
part of the group.
2. In the Pre-defined group field, press New group.
A dialogue box is displayed asking the user to enter a
name for the new group.
3. Enter the group name.
4. Press OK.
The new group is displayed in the Pre-defined group field.
Updating an existing group
A selected group is
highlighted by a
yellow frame.
1. In the Pre-defined group field, select the group to edit.
The selected cell are highlighted in the Protocol template
preview field.
2. Either select (a) new cell(s) to add to the group or deselect
(an) existing cell(s) to remove from the group.
3. Press Update group in the Pre-defined group field.
The display in the Protocol template preview field is
updated accordingly.
Deleting a group
A selected group is
highlighted by a
yellow frame.
1. In the Pre-defined group field, select the group to delete.
2. Press Delete group.
The group is removed from the list in the Pre-defined
group field.
To Next Page
Loading...
