Measurement and Analysis
254 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
To assign a user-defined parameter label
1. Trackball to the actual measurement in the Measurement
result table (see Figure 7-4).
2. Press
SET.
A Parameter label menu is displayed.
3. Trackball to User and press
SET.
The Enter new parameter window is displayed.
Figure 7-5: The Enter new parameter window
4. Type a name for the parameter label.
5. Press OK.
The user defined parameter label is assigned to the
selected measurement.
To Next Page
Loading...
