Report
524 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
Figure 10-20: The Measurements box
4. Enter a heading (e.g. 2D).
5. Using the Filter criteria, define the type of measurements to
be entered (e.g. Cardiac, 2D, measured and calculated).
Select Show normal value to display user-defined Normal
value next to the measurements in the Report (see
page 340 for more information).
Note: References for the normal values can be displayed
in the report by checking Normal value references from
Insert -> Archive Info (see page 522)
6. From the measurement list, select the measurement to
insert and press Add. Both single measurements or a folder
may be added.
7. The list of the inserted measurements is displayed in the
Selected measurement list on the right side.
8. Press OK.
9. Select the next table cell and repeat steps 3 to 8 to insert
several measurements.
To Next Page
Loading...
