Scanning Modes
154 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
Conventional Color M-Mode
1. While in Color Mode press cursor on the control panel.
2. Use the trackball to position the cursor over the required
area of the image.
3. Press
M - the Color M-mode sweep will start to sweep.
4. Press
FREEZE to stop imaging.
OR
1. While in Color Mode press
M on the control panel. The
Color M-mode sweep will start to sweep.
2. Use the trackball to position the cursor over the required
area of the image.
3. Adjust horizontal sweep, Gain, Frequency, Focus, Dynamic
Range, Compression and Contour to optimize the display if
necessary.
4. Press
FREEZE to stop imaging.
Anatomical M-Mode
Anatomical M-Mode is only available for cardiac applications.
Anatomical
M-Mode can also be
used with previous-
ly acquired digitally
stored 2D images.
1. Enter live M-mode.
2. Press the assignable
AMM soft key to enter Live
Anatomical M-mode. Continue to step 4 below.
OR
While in 2D-Live or 2D-Freeze modes, press
ALT button and
press the assignable
AMM soft-key
OR
1. From the 2D Live, press
FREEZE.
2. Press
M to access the Freeze Anatomical M-Mode.
The Trackball as-
signable Pos (Posi-
tion) is activated.
3. Use the trackball to position the cursor over the required
area of the image.
The Trackball as-
signable Angle is
activated.
4. Press SET to allow free rotation of the solid full-length cursor
line throughout the 2D image.
5. Rotate the solid cursor line to the desired direction.
The Trackball as-
signable Pos is acti-
vated.
6. Press SET twice and reposition the intersection point to the
desired position along the cursor line.
7. Repeat steps 4. and 5. to change the angle of the solid
cursor line if necessary.
To Next Page
Loading...
