Safety
42 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
Electromagnetic Compatibility (EMC)
NOTE: This unit carries the CE mark. It complies with
regulatory requirements of the European Directive 93/42/EEC
concerning medical devices. It also complies with emission
limits for a Group 1, Class B Medical Device as stated in
IEC/EN 60601-1-2 (2001).
All types of electronic equipment may characteristically cause
electromagnetic interference with other equipment, transmitted
either through air or connecting cables. The term
Electromagnetic Compatibility (EMC), indicates the capability
of the equipment to curb electromagnetic influence from other
equipment, while at the same time not affecting other
equipment with similar electromagnetic radiation.
Radiated or conducted EMC can cause distortion, degradation,
or artifacts in the ultrasound image which could potentially
obscure diagnostic information.
There is no guarantee that interference will not occur in a
particular installation. If this equipment is found to cause or
respond to interference, which may be determined by turning
equipment on and off, qualified service personnel should
attempt to correct the problem by one or more of the following
measures:
• Re-orient or re-locate the affected device.
• Increase the separation between the unit and the affected
device.
• Power the equipment from a source other than that of the
affected device.
• Consult the service representative for further suggestions.
The manufacturer is not responsible for any interference or
responses caused by the use of interconnecting cables other
than those recommended, or by unauthorized changes or
modifications to this unit. Unauthorized changes or
modifications could void the user's authority to operate the
equipment.
To comply with the regulations on electromagnetic interference,
all interconnecting cables to peripheral devices must be
shielded and properly grounded. Use of cables not properly
shielded and grounded may result in the equipment causing or
To Next Page
Loading...
