Presets and System setup
632 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
TCP-IP
This configuration category enables the user with
administration rights to set the Transmission Protocol/Internet
Protocol for the system and connected remote archive.
Figure 13-20: The sublevel TCP/IP
1. Computer name: device’s name of type VIVID_S5-00nnnn or
VIVID_S6-00nnnn or ECHOPAC7-00nnnn, where “nnnn” is the system’s
serial number. Do not change the computer name.
2. IP settings: system IP settings
3. Remote archive setup: remote archive IP address and name (EchoPAC PC
or Image Vault)
4. Save TCP/IP settings. The changes will be effective after the system is
rebooted.
5. Advanced DICOM log: creates a detailed DICOM related report log. Should
be used only if DICOM issues are registered (see page 646 about report log
generation).
To Next Page
Loading...
