GE Vivid S6 - Configuration of the Measurement Menu

Presets and System setup
Vivid S5/Vivid S6 User Manual 601
R2424458-100 Rev. 2
Configuration of the Measurement
menu
There are many more measurements and parameters in the
measurement package than shown in the default Measurement
menu. Use the configuration system to set up the
measurements that should be available in the Measurement
menu and which parameters should be calculated (see also
"Measurement package configuration" on page 338).
Display of the Measurement categories
1. Press M&A categories in the Configuration window.
The M&A categories are displayed in a pop-up window
(see page 599).
2. Check the categories to be displayed.
Uncheck the categories to hide.
To copy a Measurement category
1. Press M&A categories in the Configuration window.
The M&A categories are displayed in a pop-up window
(see page 599).
2. Move the trackball marker over the M&A category name.
3. Press
SET to highlight the category.
4. Press Create copy.
A copy of the selected measurement category is displayed
in the Measurement menu.
Factory Measure-
ment categories
cannot be renamed.
To rename the Measurement category:
1. Select the Measurement category in the Measurement
menu.
2. Enter a new name in the Measurement field.
Selection of a Measurement category
1. Trackball to the Measurement menu heading.
2. Press
SET.
The measurement categories are displayed in a
sub-menu.
3. Trackball to the measurement category of interest.
4. Press
SET.
The measurement category is displayed.