Scanning Modes
Vivid S5/Vivid S6 User Manual 189
R2424458-100 Rev. 2
TSI controls
TSI assignable controls
Invert
Invert is available for TEE acquisitions. When applied, the time
to peak negative
velocity is calculated (instead of the time to
peak positive velocity). Invert makes it possible to use TSI on
TEE acquisitions where the image sector is inverted.
Frame rate
Controls the line density. When adjusting frame rate, there is a
trade-off between spatial and temporal resolution.
TSI
Starts/stops TSI Mode.
TSI Start
This rotary allows manual adjustment of TSI starting point.
TSI End
This rotary allows manual adjustment of TSI ending point.
Note: While in Freeze, press
MORE to see the TSI Start / End
controls.
Q-analysis (in Freeze only)
Starts the Quantitative analysis application (see Chapter 8,
"Quantitative Analysis" on page 375).
Simultaneous
Enables simultaneous display of 2D image and 2D image with
TSI color.
Cineloop (in Freeze only)
Starts cineloop acquisition.
Color maps
Displays a menu of color map options. Use the assignable
rotary knob to select and activate a desired color map.
To Next Page
Loading...
