Stress Echo
212 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
The views that are
already assigned are
tick marked (see
Figure 5-7).
3. Trackball to the required view name.
4. Press
SET.
The name of the view is displayed above the timers in the
loop window.
5. Repeat steps Figure 1 through Figure 4 to assign loops to
the other views of the level.
6. Press the assignable
DONE when completed.
A dialogue window is displayed asking whether the entire
Continuous capture acquisition should be saved or not.
7. Press Delete to discard the acquisition.
Saving the entire
acquisition may
take a few seconds
on the local hard
disk and several
minutes on a re-
movable media.
OR
Press Store all to keep the entire acquisition.
The normal procedure is to discard the acquisition. The
acquisition is very big and will take a lot of disk space.
Figure 5-7: Loop assignment in Continuous capture
1. Assigned loop
2. Highlighted loop
3. Views pop-up menu
4. Highlighted views
5. Already assigned view
To Next Page
Loading...
