Measurement and Analysis
300 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
The results are summarized in the worksheet and in the report
(Figure 7-32 and Figure 7-33).
To exit the AutoEF package:
Press Measure to exit AutoEF.
Whenever pressing Worksheet , Patient, or 2D the system
closes the AutoEF package.
Before AutoEF closes a prompt appears: Do you want to store
the loop? Click Yes to store the loop or No to discard it.
Note: Do not disable any sub-measurement of AutoEF using
Config. tab, as this will disable the whole set of AutoEF
measurements.
Figure 7-32: Results in worksheet
To Next Page
Loading...
