Measurement and Analysis
Vivid S5/Vivid S6 User Manual 347
R2424458-100 Rev. 2
User-defined measurements
Some user-defined formula may require measurements that do
not exist on the system. The following example based on a
generic distance measurement illustrates how to create
user-defined measurements.
Figure 7-55: The Measurement menu sheet
1. Press CONFIG and select the category Meas/Text.
2. In the Measurement menu sheet, select the appropriate
scanning mode for the measurement to be created (e.g.
2D).
3. Select the appropriate folder in the Measurement menu
(e.g. Dimension).
4. Press Add Measurement in the Measurement menu
sheet.
The Add measure window is displayed.
Figure 7-56: The Add measure window
1. Select the appropriate scanning mode.
2. Select the appropriate folder.
3. Press Add measurement.
To Next Page
Loading...
