Presets and System setup
Vivid S5/Vivid S6 User Manual 595
R2424458-100 Rev. 2
Creating a new Application
The application created is probe dependant. Select the desired
probe before configuring a new application.
1. Press
APPLICATION on the Control panel.
2. Highlight the probe and press
SET.
3. Trackball to Presets...
A pop-up window Enter new name: appears.
4. Enter a name for the new application.
5. Press Save.
To edit an application
1. Press APPLICATION, select the probe, and select the
application to edit.
2. Adjust the imaging parameters as desired.
3. Press
APPLICATION.
4. Highlight the probe and press
SET.
5. Trackball to Presets...
A pop-up window Enter new name: appears, displaying the
current preset name.
6. Press Save to store the changes.
Applicable only on user-defined applications.
Create new application:
Press New to create a new Application. A
dialogue window is displayed where the
operator is asked to give a name to the
new application.
Remove current application:
Press Delete to remove the current
application. Factory Application settings
cannot be deleted.
Save image/appl. settings
Press Save to store the changes applied
to the current setting. Not applicable on
factory application settings.
Parameter Description
To Next Page
Loading...
