Presets and System setup
Vivid S5/Vivid S6 User Manual 621
R2424458-100 Rev. 2
To select the default dataflow
1. Select the dataflow in the Name drop-down menu. (see
Figure 13-15).
2. Check the Default box.
The dataflow will be selected by default when restarting
the unit.
3. Check the Direct Store box to have data stored
automatically to the archive (no buffer storage).
Adjusting the assigned devices
1. Select the device in the Selected devices field.
2. Press Properties.
The Properties window is displayed.
3. Adjust the device specific parameters as desired (see table
below). Not all the settings listed below apply to all devices.
General settings Definition
Name Free text: give a descriptive name for the device.
IP address Select from drop-down menu
Database Name Automatically selected according to the IP address
File destination Automatically selected according to the IP address
Removable Check the entry is the media is removable.
MPPS Modality Perform Procedure Step: send information
(typically to a HIS) that a scheduled exam has been
started, performed or interrupted.
Image settings Definition
Allow raw data
: save data in both raw and DICOM format.
: save data in DICOM format only.
Raw Compression Enables compression of raw data images upon storage
and export. Raw compression is active only if the setting
Allow raw data is checked.
Max Framerate Select 25, 30 or Full from the pop-up menu. Full (original
acquisition) is default.
Compression Select compression type or no compression.
To Next Page
Loading...
