Presets and System setup
624 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
P1/P2 Print key configuration
1. In Button field select Print P1 or P2.
2. Select an output device in the available outputs field and
press the Right arrow button to assign the service to the
dataflow. The Properties window is displayed
3. Adjust the device specific parameters and select OK.
Some of the settings can be changed directly in the Image
to Produce field in the sublevel Additional outputs.
4. Adjust the image specific parameters (see the table below).
To remove a device, select the device in the Selected devices
field and press the Left arrow button.
Configuration parameter
Format Select between:
• Raw DICOM
• DICOM
Image compression Select compression mode from the pop-up menu.
Quality When JPEG compression is selected, adjust the picture
quality between 1 and 100%. A low picture quality level
allows high data compression, while a high picture quality
restrains the compression.
Image frames Select between:
• Single: stores single frame only
• Multiple: stores cineloop
• Secondary Capture: screen shot
Capture Area Select between:
• Video Area (1)
• Whole Screen (2)
To Next Page
Loading...
