Getting started
56 Vivid S5/Vivid S6 User Manual
R2424458-100 Rev. 2
Connecting to the electrical outlet
1. Ensure that the wall outlet is of appropriate type, and that
the power switch is turned off.
2. Uncoil the power cable, allowing sufficient slack so that the
unit can be moved slightly.
3. Attach the power plug to the system and secure it in place
by using the retaining clamp.
4. Secure the power plug in the wall outlet.
Figure 2-4: Power plug
WARNING
POWER OUTAGE MAY OCCUR. The Vivid S5/Vivid S6 requires a
dedicated single branch circuit. To avoid circuit overload and
possible loss of critical care equipment, make sure you DO NOT
have other equipment operating on the same circuit.
The unit’s power must be supplied from a separate, properly
rated outlet to avoid risk of fire. Refer to "Power requirements"
on page 53 for rating information.
The power cord should not, under any circumstances, be altered
to a configuration rated less than that specified for the current.
Do not use an extension cord or adapter plug.
a. Retaining clamp for power plug
CAUTION
Ensure that the retaining clamp for the power plug is fixed firmly.
To Next Page
Loading...
