Geeetech Prusa I3 Pro C - Mount the PSU

71
GEEETECH
26 Mount the PSU
Watch the video
This video shows the mounting of the PSU for single extruder, this step is the same;
you can refer to the pictures below.
The only difference is that there are 9 connectors for the PSU for dual extruder.
If you have any problems here, please feel free to contact us.
Pic
Part ID
Required number
Required parts
NO.61
1
Power supply
NO.25
3
M3 x 10 screw
NO.34
2
M3 x 16 bolt
NO.11
2
M3 nut
NO.57
1
3D Power cable
NO.58
1
Power Cab
l
e
Step1. Take off the wires connected to the socket; before you do, please take a photo
of the wire connection, in case you connect them wrongly later.