ADV200 SP • Quick start up guide - Specification and installation 41
T+ T-ENLOC ILim n:0 AL
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
T+ T-ENLOC ILim n:0 AL
27 MACRO
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
T+ T-ENLOC ILim n:0 AL
01 MONITOR
02 DRIVE INFO
03 STARTUP WIZARD
04 DRIVE CONFIG
T+ T-ENLOC ILim n:0 AL
26.01 PID 1 REFERENCES
26.02 PID 1
26.03 PID 2 REFERENCES
26.04 PID 2
T+ T-ENLOC ILim n:0 AL
23 COMMUNICATION
24 ALARM CONFIG
25 ALARM LOG
26 PROCESS
1st level 2nd level
(*)
Export mode (see paragraph 6.5.2).
6.2.2 Display of a parameter
T+ T- EN LOC ILim n:0 ALT+ T- EN LOC ILim n:0 AL T+ T- EN LO C ILim n:0 AL
2
13. 05
PA R:1330
Di
g
out1inversion
16.01
PA R:2000
Rated volta e
g
+
400 V
05.04
PA R: 610
Ram ref1src
p
Mlt ref out mon
1
3
4
Def: +400
ABC
T+ T- EN LOC ILim n:0 ALT+ T- EN LOC ILim n:0 AL T+ T- EN LO C ILim n:0 AL
2
04.0 1
PA R: 550
Save arameters
p
04.02
PA R: 552
Re
g
ulation mode
V/f control
01.01
PA R: 250
Out
p
ut current
+0.3
A
1
3
4
Value: 0
DEF
ON
Value: 2034
PressEto execute
Param read onl
y
T+ T- EN LOC ILim n:0 AL
2
Autotune
1
3
4
Error code: 1
G
Press ESC to exit
1
2 Description of the parameter.
3 Depends on the type of parameter:
displays the numeric value of the parameter, in the format required, and unit of
Binary selection:
Command:
4
displays the default, minimum and maximum values of the parameter. These values
Command:
command (figure G).
Messages and error conditions (figure F):
Param read only attempt to modify a read-only parameter
Password active the parameter protection password is active
Drive enabled
Input value too high
the value entered too high
Input value too low
the value entered too low
Out of range attempt to insert a value outside the min. and max. limits
To Next Page
Loading...
Need help?
General
