ADV200 SP • Quick start up guide - Specification and installation 45
6.6 Alarms
The alarms page is displayed automatically when an alarm occurs.
T+ T- EN LO C ILim n:0 AL
Alarm
-RTN : 1/2
Power down
Time: 28:04
Code: 0000H-0
1 Alarm
x/y
lowest x is the most recent)
2 Description of the alarm
3
4 Moment of occurrence of the alarm in machine time.
6.6.1 Alarm reset
Pressing the RST key, the alarms are reset and all alarms reset are eliminated from the list.
If, after this operation, the list of alarms is empty, the alarm page is closed.
Pressing the RST key, the alarms are reset.
If active alarms are still present following reset, the alarm page is opened.
Note ! For further information, see chapter 8.2.
6.7 Messages
Operator messages are displayed with this page.
The messages are of two types:
- timed
- xed (remain displayed until the operator presses the ESC key).
Several concurrent messages are enqueued and presented to the operator in sequence, starting from the most
recent.
T+ T- EN LO C ILim n:0 AL
Message
01
Load default
Press ESC to exit
Code: 0001H-1
1 MESSAGE
xx indicate show many messages are enqueued. The queue may contain a maximum of 10 messages and
2 Description of the message (see chapter 8 for further information)
3
4
When a message is closed, the next message is displayed until the queue is empty.
To Next Page
Loading...
Need help?
General
