gefran ADV200 SP Series - Transfer of Parameters between Drives

ADV200 SP • Quick start up guide - Specification and installation 47
If an error occurs during transfer, the following message is displayed:
T+ T- EN LOC ILim n:0 AL
Message
01
Load par failed
Press ESC to exit
Code: XX
The code XX indicates the type of error, see paragraph 8.2.
To exit from the error message, press the ESC key.
6.8.4 Transfer of parameters between drives
Transfer the parameters of the source drive to the keypad memory as indicated in paragraph 6.8.2, then con-

6.8.3.

OFF.
Pour éviter tout endommagement possible des appareils, il est conseillé de débrancher et de brancher le pavé
de commande une fois le drive éteint.
Caution