ADV200 SP • Quick start up guide - Specification and installation 59
7.3 Programming
7.3.1 Menu display modes
Access mode pa-
chapter 6.5.2:
• Easy (default) only the main parameters are displayed.
• Expert all the parameters are displayed.
7.3.2 Programming of “function block” analog and digital input signals
src Ramp ref 1 src, PAR: 610)
the source of the function block input,
selection lists.
cfg Mpot init cfg, PAR: 880)
This term refers to .
For example: Ramp times, internal reference adjustment, etc...
mon Ramp ref 1 mon, PAR: 620)
This term refers to the variable output from the function block, which is the result of the
calculations performed on the actual block.
X
Input selected
Parameter
Parameter
Parameter
Variable
7.3.3 Variable interconnections mode
The source (src)
1 – Physical terminal
The analog and digital signals come from the terminal strip of the regulation card and/or from those of the
expansion cards.
2 – Drive internal variables
Practical example
The following examples illustrate the philosophies and methods with which more or less complex operations
To Next Page
Loading...
