68 ADV200 SP • Quick start up guide - Specification and installation
Index Error message shown
on the display
Sub-code Description
0017H-23 The configuration required is not available on the power card
Solution: Download the correct configuration on the power card
7 Save par failed
Condition: during transfer of the parameters from the drive to the memory of the keypad
0H-0 Communication error
0025H-37 The data saved on the keypad are not valid
0026H-38 Incompatible drive series
0027H-39 Incompatible software version
0028H-40 Incompatible drive size
0029H-41 Error during saving of parameters on the drive
Solution:
8 Load par failed
Condition: during transfer of the parameters from the memory of the keypad to the drive
9 Load par incomplete
0H-0 Communication error
0025H-37 The data saved on the keypad are not valid.
No parameter is transferred from the keypad to the drive
0026H-38 Incompatible control type.
No parameter is transferred from the keypad to the drive
0027H-39 Incompatible software version.
All the parameters present in the memory of the keypad have been transferred to the drive. The set of
parameters transferred refers to a drive with a different firmware version; therefore, certain param-
eters may not be updated.
0028H-40 Incompatible control type.
All the parameters present in the memory of the keypad (excluding those that depend on the size
of the drive), have been transferred to the drive. The parameters that depend on size maintain their
original value.
0029H-41 Error during saving of parameters on the drive.
All the parameters present in the memory of the keypad have been transferred to the drive. The trans-
fer of one or more parameters has caused an “out of range” error, or one or more parameters does not
exist. At the end of transfer, one or more parameters may not have been updated.
002AH-42 PLC application release and version not compatible.
All parameters in the keypad memory have been transferred to the drive.
The transferred set of parameters relates to a drive with a PLC application in which the version and
release of the application are different. As a result some of the PLC application parameters may not
be updated.
002BH-43 PLC application not compatible.
All the parameters in the keypad memory except those relating to the PLC applciation have been
transferred to the drive.
The transferred set of parameters relates to a drive with a different PLC application. As a result none
of the PLC application parameters are updated.
Solution: Recover a set of parameters from a compatible drive (model and size)
10 Options config error Condition: may occur at drive start-up, during recognition of the optional cards installed
0001H-1 Non-permissible optional card in slot 1
0002H-2 Non-permissible optional card in slot 2
0004H-4 Non-permissible optional card in slot 3
0010H-16 Conflict slot 1 with slot 2
0020H-32 Conflict slot 1 with slot 3
0040H-64 Conflict slot 2 with slot 3
Solution: Remove the optional cards from the incorrect slots and insert them in the correct slots
11 Load def plc
Condition: may occur during loading of the parameter database saved in the Flash of the Mdplc application
Normally appears at initial power-on after downloading a new application.
If this message is displayed when the drive is already operating, this means that a problem has occurred in the param-
eter database saved in Flash.
If this message appears the drive restores the default database, i.e. the one that was downloaded.
To Next Page
Loading...
Need help?
General
