119 50940193/DP0415
3. When all three checkmarks (A, B & C) are
displayed on the Stationary Regeneration
screen, press and hold the button (Z) until
the Stationary Regeneration In-Progress
screen displays (Figure 84)
Note: Stationary regeneration can be
interrupted at any time by releasing the
parking brake, advancing the throttle, or
stopping the engine. Stationary regeneration
must start again from the beginning if it is
interrupted.
Stationary regeneration completion percentage
is displayed as during the stationary regeneration progresses. Progress percentage
disappears when stationary regeneration completes.
Note: Stationary regeneration takes approximately 25-30 minutes.
It is not necessary to stay in the machine during
stationary regeneration. Keep the machine under
observation while regeneration is in progress in case of malfunction.
Keep bystanders away from the machine while regeneration is in
progress.
Forcing Stationary Regeneration
Stationary regeneration can be performed at any time after 50 operating hours following
the previous stationary regeneration.
To perform stationary regeneration on-
demand:
Press button (Y, Figure 85) associated with the
DPF regeneration symbol (X), until the
regeneration screen displays. Refer to
“Stationary Regeneration” on page 118 to
proceed with stationary regeneration.
22 %
Figure 84 – Stationary Regenera-
tion In-Progress Screen
Figure 85 – Forcing Stationary
Regeneration
Y
X
To Next Page
Loading...
