39 50940193/DP0415
CHAPTER 3
SAFETY EQUIPMENT
Become familiar with all safety devices on the
machine before starting. Know how to stop the
machine before starting it. The machine is designed and intended to be
used only with Manitou Americas-approved attachments or accessories.
Manitou Americas cannot be responsible for operator safety if the
machine is used with unapproved attachments.
Guards and Shields
Guards and shields are provided on the machine, wherever possible without effecting
machine operation, to protect against potential hazards. In many places, safety decals are
also provided to warn of potential hazards and/or to display special operating procedures.
Read and thoroughly understand all safety decals
before operating the machine. Do not operate the
machine unless all factory-installed guards and shields are properly
installed and secured in place.
Operator’s Position
Operator’s Seat
Never adjust
the seat during
machine operation. Adjust the seat
only when the machine is stopped
and the restraint bar is in the raised
position. After adjustments, make
sure the seat is securely locked in
place before using the machine.
Horizontal adjustment: The seat is mounted
on rails to allow forward and back horizontal
position adjustment.
Use lever (A, Figure 4) to move the seat
forward or back as desired. Release handle (A)
when the seat is in the desired position. Make sure the seat is locked in position after
adjusting.
Figure 4 – Operator’s Seat
Horizontal Adjustment
A
To Next Page
Loading...
