184 50940193/DP0415
Diesel Fuel
Tank
DPF Models:
ULSD
a
ultra-low sulfur only,
below 15 PPM.
ASTM D975 with biodiesel
content limited to 5% of DIN
EN14214 type (no additives
allowed!)
62.5 L (16.5 gal.)
Non-DPF Models:
ASTM D975-94 (no additives
allowed!)
DIN EN14214 Biodiesel (no
additives allowed!)
LSD or ULSD
a
low sulfur or
ultra-low sulfur, below 500
PPM. Up to 5% (B5) mixture of
BioDiesel allowed
Engine Coolant
Long life coolant ASTM D4985,
D6210 (United States) SAE
J814C, J1941, J1034 or J2036
(international)
(See “Coolant Compound
Mixtures” on page 189)
9.5 L (2.5 gal.) 14.4 L (3.8 gal.)
Radiator Cap
Pressure
N/A 1.10 bar (16 psi)
Chaincase
(each)
SAE grade 10W-30 motor oil 7.1 L (7.5 qts.) 9.5 L (10 qts.)
Motor Gearbox Drive motor mechanism lubricated by hydraulic system oil.
a. Ultra-Low Sulfur Diesel (ULSD) fuel lubricity must have a maximum scar diameter of 0.45 mm, as
measured by ASTM D6079 or ISO 12156-1, or a minimum of 3100 grams as measured by ASTM
D6078. Contact your fuel supplier for details. Specification 1-D S15 or 2-D S15, ASTM D975.
Table 30: Fluid Capacities/Lubricants
Component/
Application
Type R135 R150 R165
To Next Page
Loading...
