Rev. 00 12/22
OptiMove CR09-C Product description • 13
Product description
Intended use
The axis control unit is designed exclusively for operating electrically
driven axes in electrostatic powder coating equipments.
Fig. 1: Axis control OptiMove CR09-C
Observance of the operating, service and maintenance instructions
specified by the manufacturer is also part of the intended use. This
product should only be used, maintained and started up by trained
personnel, who are informed about and are familiar with the possible
hazards involved.
Any other use is not considered as intended use. The manufacturer is not
responsible for any incorrect use and the risks associated with such
actions are assumed by the user alone!
For a better understanding of the interrelationships in powder coating, it is
recommended that the operating instructions for all other components be
read as well, so as to be familiar with their functions too.
To Next Page
Loading...
Need help?
General
