Rev. 00 12/22
OptiMove CR09-C Safety • 9
Safety
Basic safety instructions
– This product is built to the latest specification and conforms to the
recognized technical safety regulations and is designed for the
normal application of powder coating.
– Any other use is considered non-compliant. The manufacturer shall
not be liable for damage resulting from such use; the user bears sole
responsibility for such actions. If this product is to be used for other
purposes or other substances outside of our guidelines then Gema
Switzerland GmbH should be consulted.
– Start-up (i.e. the execution of intended operational tasks) is
forbidden until it has been established that this product has been set
up and wired according to the guidelines for machinery. The
standard "Machine safety" must also be observed.
– Unauthorized modifications to the product exempt the manufacturer
from any liability from resulting damage.
– The relevant accident prevention regulations, as well as other
generally recognized safety regulations, occupational health and
structural regulations are to be observed.
– Furthermore, the country-specific safety regulations also must be
observed.
Product specific safety information
– This product is a constituent part of the equipment and is therefore
integrated in the system's safety concept.
– If it is to be used in a manner outside the scope of the safety
concept, then corresponding measures must be taken.
– Installation work performed by the customer must be carried out
according to local regulations.
– All components must be grounded according to the local regulations
before start-up.
To Next Page
Loading...
Need help?
General
