Rev. 00 03/19
34
Start-up OptiStar 4.0 (CG24-CP)
System parameter P00 (device type)
Fig.
: System parameter P00
A wrong parameterization leads to various malfunctions!
► The system parameter P0 must be set to 6 (Application pump +
CAN bus)!
System parameter P03 (measuring unit)
fig.
: System parameter P03
This parameter is used to determine the measuring unit for all airs (total
air and electrode rinsing air). If the parameter is set to 1 (scfm), then all
air values are shown in this measuring unit. These lines are displayed in
blue.
To Next Page
