10-3
Wall Mount Control Box
G990710 30 June 2008
5.
Mount Wall Bracket,
using supplied mounting
hardware (3 places).
6. Hang Control Box onto
wall mount bracket.
The Control Box can be
lifted from the wall for
mobility. For a stationary
mount see next
procedure.
For a Stationary Mount
7. Draw center marks in the two
tab slots at the rear of the base.
8. Drill two 3/32” pilot holes.
9.
With the Control Box
positioned on wall bracket,
install the two self-tapping
screws (supplied with wall
bracket).
Refer to install diagram
(supplied with wall bracket).
To Next Page
Loading...
