3-2
Gendex GXCB-500
TM
Service Manual
G990710 30 June 2008
Patient Emergency Stop Control
PATIENT EMERGENCY STOP allows the
Patient to halt all X-ray and scanning activities by
pressing the button.
The Emergency Stop Control can either be hung
from the head support mechanism or held in the
Patient’s hand as desired.
Patient Alignment Panel
Laser beams can cause optical damage. Do not stare into the laser
beam. Instruct the Patient to avoid looking into the beam. The use of
optical instruments such as eyeglasses with large diopter or mirrors,
increase eye hazard with this product.
ALIGNMENT LIGHT - pressing the button turns ON
the laser alignment lights for two minutes, or until the
button is toggled OFF.
PATIENT ALIGN allows the Operator to move the
Patient seat up and down to facilitate Patient alignment
with the Chin Rest.
System Status Indicators
The System Status Indicators are located on both the
overhead unit and the Operator Control Box.
POWER indicator is lit when the scanner is ON.
READY indicator is lit when the software Acquire
button is pressed to begin the scanning process.
X-RAY ON indicator is lit during the scanning process.
FAULT indicator lights when a system error occurs
(such as an x-ray exposure problem).
To Next Page
Loading...
