A-7
G990710 30 June 2008
Configure iCATTransfer
1. Launch iCATTransfer, the following window is displayed.
2. Under Folder to Watch, Browse to iCATVision\ iCATVision
Watch folder and select. (This is most likely on the C: drive of
the iCAT
®
Acquisition Computer).
3. Under Image Root Folder (Primary Destination), Browse to
iCATVision Root folder and select. (This is most likely on a
server/central storage location).
4. Click Start. This saves the preset Watch and Root destinations.
NOTE: If START is not clicked the transfer program will not work.
Remember, iCATTransfer must be running in order for the data to
transfer (iCATTranfer can be minimized).
Accessing i-CAT
®
DICOM Data
iCATTransfer requires data to be exported from the iCAT
®
software
in DICOM3 format.
To Next Page
Loading...
