1. Enable NTP.
2. Type the IP address of the network time server next to NTP Server IP.
3. Click Save.
4.10.2 Server
Note this function is NOT applicable to GV-SD2322-IR.
Server allows you to quickly access the FTP setting page. Click the FTP button to go to the
FTP settings page and complete the storage settings. See 4.8.3 FTP for details.
Figure 4-78
4.10.3 DST
To adjust the camera’s time for daylight saving time:
1. Click the DST tab at the top.
Figure 4-79
2. Select Enable DST / ON.
3. Set a Start Time and End Time for the daylight saving time.
4. Select a time period for DST Bias.
5. Click Save.
To Next Page
Loading...
Need help?
General
