4.6.7 Face Detection
The Face Detection function can detect for and capture faces to be sent to an FTP server.
Select the checkbox next to Face to enable and click to configure.
Figure 4-45
1. Once enabled, define the detection area, either by selecting Specified Area and
drawing a desired area on the image, or select Full Screen to set the entire image as
detection area.
2. Configure the following functions as needed:
[Face Detection]
Snapshot Sensitivity: Drag the slider to adjust the detection sensitivity.
Snapshot Mode:
i. For GV-SD2722-IR / SD3732-IR, Select Intelligent Recognition to set the
maximum of repeated face snapshots (1~30) for Max. Same Thumbnail Image.
ii. For GV-SD4825-IR / SD4834-IR, Select Intelligent Recognition for the
camera to detect and take snapshots of the object automatically.
Human Body Snapshot: To take a snapshot of human body in the detection area,
enable this function. (Only for GV-SD4825-IR / SD4834-IR)
To Next Page
Loading...
Need help?
General
