4.1.2 Local Settings
You can set local parameters for your PCs.
Figure 4-3
[Intelligent Mark]
◼ Untriggered Target: Displays the detection lines / areas defined by Smart Settings on
Live View. You must set up Smart Settings first for this function to work, see 4.6
Intelligent. Note this function is not supported by GV-SD2322-IR.
◼ Display Attributes: When enabled, the attributes collected will be displayed in the live
view window. You must set up Attribute Collection for this function to work (see 4.6.10
Attribute Collection). Note this function is only applicable for GV-SD4825-IR / SD4834-
IR.
◼ Display Human Body Snapshot: To display the snapshot of human body on the live
view window, make sure Human Body Snapshot is enabled in Face Detection (see
4.6.7 Face Detection).
To Next Page
Loading...
Need help?
General
