[Video]
◼ Processing Mode (for GV-SD2722-IR / SD3732-IR)
Real Time Prior / Real Time Priority: Select this if the network is in good condition.
Fluent Prior / Fluency Priority: Select this if you want short time lag for live video.
Ultra-Low Delay / Ultra-Low Latency: Select this if you want the minimum time lag
for live video.
◼ Display Mode (for GV-SD4825-IR / SD4834-IR): Set the display mode according to the
network status, including Min. Delay, Balanced Delay, and Fluent Delay for low to
high delay. Or customize the display mode parameters by selecting Customize.
◼ Video Pixel Format: Select the video format for images at your local computer. It is
recommended to choose YUV420 if the graphic card of your PC supports it. This
function is only applicable to GV-SD2322-IR.
◼ Protocol: Select the protocol used to transmit media streams to be decoded by the PC.
[Audio Param] The audio codec and sampling rate used are shown here.
[Recording and Snapshot]
◼ Recording
Subsection By Time: Set a maximum time length of each recording file. If you
select 5 minutes, a 30-minute event will be chopped into six 5-minute event files.
Subsection by Size: Set a maximum size limit of each recording file.
◼ When Storage Full
Overwrite Recording: When the assigned storage space on the computer is used
up, the camera deletes the existing recording files to make room for the new
recording file.
Stop Recording: When the assigned storage space on the computer is full,
recording stops automatically.
◼ Total Capacity: Set a capacity limit to the assigned storage space on the computer.
◼ Recording Folder / Files Folder: Click Browse to set a folder to store the recorded
videos at your local computer.
◼ Snapshot Folder: Click Browse to set a folder to store the captured snapshots at your
local computer. To assign the snapshot-storing location for GV-SD2722-IR / SD3732-IR,
go to Storage in the left menu and select FTP.
To Next Page
Loading...
Need help?
General
