4.3.3 Snapshot
This function is NOT applicable to GV-SD2322-IR.
Using the Snapshot function, when an alarm is triggered, the camera will automatically
upload the captured snapshots to the FTP server or send snapshots to the specified e-mail
address.
Note: If Upload Images is selected in Figure 4-66, 4.8.3 FTP, the captured snapshots will
only be sent to the FTP server.
Figure 4-17
1. Select On to enable the Snapshot function.
2. Select Resolution.
3. Specify the maximum size (1~800 KB) of the snapshot image under Max. Size.
4. Specify the length of interval (1~60 sec) between snapshots under Snapshot
Interval(s).
5. Select Number to Snapshot to define the number of snapshots upon alarm trigger.
6. Select Schedule or Repeat to set up the Snapshot Mode.
If you select Schedule, click to specify the desired time to take a snapshot.
If you select Repeat, type the interval, from 1 to 86400 seconds, to repeat the
process of taking snapshots and sending them to the FTP server or e-mail.
7. Click Save.
To Next Page
Loading...
Need help?
General
