Start or stop face snapshot.
By activating this function, the camera takes face snapshots, and
displays them on the right of the live view window. Before
activating this function, you must enable Face Detection - See
4.6.7 Face Detection. To display face attributes detected, define
Attribute Collection and enable Display Attributes beforehand -
See 4.1.2 Local Setting and 4.6.10 Attribute Collection.
For other functions in the live view window, refer to Figure 2-4.
2.2.1.1 Digital Zoom
To use the digital zoom function, follow these steps:
1. Click (No. 11, Figure 2-4) on the toolbar.
2. Click and drag on the live view from top to down to specify an area.
3. To restore the original image size, click in the enlarged area, or drag from the bottom up.
4. To exit, click (No. 11, Figure 2-4) on the toolbar.
2.2.1.2 3D Positioning (Optical Zoom)
1. Click (No. 12, Figure 2-4) on the toolbar.
2. Click and drag on the live view from top to down to specify an area.
3. To zoom out, drag from the bottom up.
4. To exit, click (No. 12, Figure 2-4) on the toolbar.
To Next Page
Loading...
Need help?
General
