◼ Clear alarm: After an alarm is triggered,
⚫ If the same alarm is not triggered within the set time, the alarm will be cleared and
the same alarm can be reported again.
⚫ If the same alarm is triggered within the set time, the alarm will not be cleared until
the suppress alarm time expires. Then the same alarm can be reported again.
6. For Trigger Actions and Plan, follow Step 5 ~ 6, 3.5.1.1 Cross Line.
Note:
1. For the Upload to FTP function, make sure to configure the settings in 4.8.3 FTP and
4.3.3 Snapshot first.
2. For the Trigger e-mail function, make sure to configure the settings in 4.2.6 E-mail and
4.3.3 Snapshot first.
3. For the Trigger storage function, make sure to configure the settings in 4.8.1 Storage.
To Next Page
Loading...
Need help?
General
